AC power supply PCR-LE series

Advanced


Using the Synchronization Function

The synchronization function synchronizes the frequency and phase of the PCR-LE Series output voltage with a 50 Hz or 60 Hz input power supply. This is valid in AC mode and AC+DC mode.

This is useful in situations such as when the display of an external measuring instrument is not stable.

Setting the synchronization delay phase angle enables you to manage the synchronization phase of the input voltage on the three-phase input model (PCR9000LE) with a high degree of precision.

Turning the synchronization function on disables the frequency limit function.

Turning the synchronization function on and off

If the input voltage frequency is outside of the rated range or if the input power supply voltage distortion and the noise are extremely large, synchronization is not possible. In these situations, “SYNC NG” is displayed.

Press SYNC (SHIFT+9) to turn the synchronization function on and off.

33379.jpg

Item

Title

Description

Valid modes

ON

Sync

The synchronization function is enabled.

“SYNC” or “SYNC+P” blinks until synchronization is established.

After a few seconds, the frequency and the phase are synchronized, “SYNC” or “SYNC+P” lights, and the synchronized frequency is displayed.

AC and AC+DC

OFF

The synchronization function is disabled.

Setting the synchronization delay phase angle

Press SYNC (SHIFT+9) and then DELAY (F4) to set the value.

33408.jpg

Item

Title

Description

Valid modes

DELAY

Sync delay deg

Sets the synchronization delay phase angle (0 deg to 359 deg)

AC and AC+DC

The frequency that is used when the synchronization function is cleared

If the frequency when you are using the synchronization function is within the frequency limits, the frequency is set to the 50 Hz or 60 Hz, whichever the PCR-LE Series was synchronized to.

If the frequency when you are using the synchronization function is outside the frequency limits, the frequency limit function will be activated.

If the frequency when you are using the synchronization function is lower than the lower limit, the frequency is set to the lower limit.

If the frequency when you are using the synchronization function is higher than the upper limit, the frequency is set to the upper limit.

Phase

The figure below shows the phase synchronization behavior for different input-wiring and output configurations.

Input wiring

  

Single-phase output

Single-phase, three-wire output

Three-phase output
(Optional)

43390.jpg

Single-phase input

43384.jpg

In-phase with the input

43372.jpg

VU-N and VL-N are in phase.

43362.jpg

Three-phase, three-wire input

PCR6000LE 200V

PCR9000LE 200 V

43351.jpg

In-phase with input VR-S

43342.jpg

VU-N and VR-S are in phase.

43330.jpg

Three-phase, four-wire input

PCR6000LE 200 V

PCR9000LE 400 V

43319.jpg

In-phase with input VR-N

43310.jpg

In-phase with the input

TOP

AC power supply PCR-LE seriesAC power supply PCR-LE series
Advanced