RMT CONT SOFTWARE FOR PCR-LE SD021-PCR-LE

Operation Guide


SD021-PCR-LE Control Procedure

This section explains the basic procedure to control the PCR-LE/PCR-LE2 from SD021-PCR-LE.

1

Select the PCR-LE/PCR-LE2 series you want to control.

Select using the IP address.

2

To control a PCR-LE2, select the output method.

Select single-phase output, single-phase three-wire output, or three-phase output.

3

Select the output voltage mode.

Select AC mode or DC mode.

4

Select the output voltage range.

Select high range or low range.

5

Set the voltage and frequency.

6

Turn the output on.

7

Start the monitor.

You can now monitor the current, voltage, power, power factor, and frequency.

SD021-PCR-LERMT CONT SOFTWARE FOR PCR-LE SD021-PCR-LE
Operation Guide