RMT CONT SOFTWARE FOR PCR-LE SD021-PCR-LE

Operation Guide


Viewing Measured Values (monitoring)

You can use SD021-PCR-LE to monitor the present output values (voltage, current, power, power factor, frequency). Measured values are retrieved from the PCR-LE/PCR-LE2 at 500 ms intervals.

1696.jpg

Tap Start to start the monitor. Tap Stop to stop the monitor.

Only the display items whose check boxes are selected appear on the monitor. Tap the check box to select or unselect it.

For single-phase three-wire output or three-phase, tap Line to display line voltages. Tap Phase to display phase voltages. This cannot be selected if the phase-voltage or line-voltage link function is enabled.

1711.jpg

SD021-PCR-LERMT CONT SOFTWARE FOR PCR-LE SD021-PCR-LE
Operation Guide