Interface Setup for PCR-M series
This interface is valid only when the optional USB interface board is installed.
A device driver supporting USB T&M Class (USBTMC) is required to control the PCR through the USB interface. The USBTMC driver is automatically installed by the VISA library.
Use a standard USB cable to connect the PCR to the computer.
1. Press CONFIG until the interface is set to "IntF."
2. Turn the rotary knob to set USB to "USb."
3. Wait at least 5 seconds, and then turn the POWER switch off and on.
The settings are applied.
The PCR is equipped with service request and serial polling functions.
Complies with USB Specification 2.0
Complies with USBTMC Specification 1.0 and USBTMC-USB488 Specification 1.0
Data rate: 12 Mbps maximum (full speed)
VID （Vender ID）
PID （Product ID）