Interface Setup for PCR-LEPCR-LE2 series
This interface is valid only when the optional USB interface board is installed.
A device driver supporting USB T&M Class (USBTMC) is required to control the PCR through the USB interface. The USBTMC driver is automatically installed by the VISA library.
Use a standard USB cable to connect the PCR to the computer.
1. Press CONFIG (SHIFT+OPR MODE), COM-I/F, TYPE, and then USB.
2. Restart the PCR-LEPCR-LE2.
The settings are applied.
The PCR is equipped with service request and serial polling functions.
Complies with USB Specification 2.0
Complies with USBTMC Specification 1.0 and USBTMC-USB488 Specification 1.0
Data rate: 12 Mbps maximum (full speed)
VID （Vender ID）
PID （Product ID）