Sets the overcurrent protection (OCP) value.
|Value||Approximately 105 % to 110 % of the present current value (CURR; the default value is 111.5 % of the rated output current)
If you attempt to specify a value that is 105 % of the current value or less, an SCPI error (-222, "Data out of range") will occur.
If the PWX is set so that constant current is being controlled externally (CURR:EXT:SOUR VOLT), you can specify 10 % to 111.5 % of the rated output current.
For the setting that is applied when *RST or *RCL is sent, see this table.
Returns the OCP value in NR3 format in response to CURR:PROT?.