Turns the output on and off.
Use the OUTP:PON:STAT command to set the output condition that the PWX will be in when the power is turned on.
If the PWX is set so that external control is used to turn output is on and off, an SCPI error (-221, "Setting conflict") may occur depending on the on/off logic setting and the level of the signal applied to pin 1 of the J1 connector.
|Value||ON (1)||Output on|
|OFF (0)||Output off (default)|
For the setting that is applied when *RST is sent, see this table.
Returns whether the output is on in NR1 format in response to OUTP?.