Kikusui Electronics Corp. :: Commnunication Interface Mannual

Processing time of Commands

The command processing time is the time until the next command is accepted.

It does not include the response time of the hardware.

The processing times indicated here are typical values.

They are not warranted.

 

Command GPIB
Processing Time *1
(ms)
USB
Processing Time
(ms)
RS232C
Processing Time *2
(ms)
LAN
Processing Time *3
(ms)
Description
VOLT 10 10 8 11 Sets the voltage.
MEAS:VOLT? 30 27 32 27 Queries the measured voltage output.
CURR 10 10 8 11 Sets the current.
MEAS:CURR? 28 27 32 27 Queries the measured current output.
*RST 102 102 100 102 Performs a device reset.

*1:Using GPIB-USB-B by National Instruments.

*2:Data rate setting: 19 200 bps, X-Flow control

*3:100BASE-TX Ethernet