Kikusui Electronics Corp. :: Commnunication Interface Mannual

Command (Function)

System Configuration

Setting tp be related to the Output

OUTP:EXT Sets the logic of the output on/off using external contact.
OUTP:PON:STAT Output status at power-on.
SYST:CONF:MPR Sets the output-on startup state. (Only on the PAT350-22.8T and PAT850-9.4T)

Setting of Control source

CURR:EXT:SOUR Sets the constant current control mode.
VOLT:EXT:SOUR Sets the CV control mode setting.

Breaker trip settings when protection activates.

SYST:CONF:BTR:PROT Turns breaker trip on/off when the OCP/OVP activates.
SYST:CONF:BTR:SHUT Turns the breaker trip on/off when the SD signal is applied.

Setting of Parallel Operation

SYST:CONF:PAR Setting the number of units in Master-Slave Parallel Operation.
SYST:CONF:MSL Sets the status during parallel operation.

Setting tp be related to the POWER on/off

SYST:CONF:BTR Breaker trip.
SYST:CONF:PST Sets the status signal of the power on/off.

PAT-T status

SYST:CONF:RSEN Queries the sensing switch status.

Setting of the Communication error Display

SYST:CONF:TRAC Sets whether to display or hide the communication error.

Setting of the input mode

SYST:CONF:SPH Sets the phase input mode
(Three-phase input/Single-phase input mode).

>top