Edit an existing sequence step. If the parameter is omitted, the current value is retained.



PROGram[:SELected]:NSPeed[:STEP]:EDIT? <step_NR1>

Parameter <step_NR1>

Value: 1 to 256 (Select the step number you wish to edit.)

Parameter <value_numeric>

Set the setting value which you want to execute by a step.

Setting for conductance value  PLZ-4W   PLZ-4WL/ PLZ-4WH

Setting for current value  PLZ-4W   PLZ-4WL/ PLZ-4WH

Setting for voltage value

Setting for power value

Parameter <time_numeric>

Value: 0.001 to 3599940 (999h59min), Step execution time

Parameter <load_bool>

Value ON (1) Load on
OFF (0) Load off

Parameter <ramp_bool>

Current change type

Value ON (1) Slope
OFF (0) Step

Parameter <trig_bool>

Value ON (1) Output the trigger signal during step execution
OFF (0) Not output the trigger signal during step execution

Parameter <pause_bool>

Value ON (1) Pause during step execution
OFF (0) Not pause during step execution


Returns the setting of step of the selected program (value, step execution time, load on/off, current change type, trigger on/off, and pause on/off) in order in the comma-separated NR3,NR3,NR1,NR1,NR1,NR1 form in response to PROG:NSP:EDIT? <step_NR1>.




Overview of Messages

Command (function search)

Command (ABC search)

Command (Sub-system search)